[Histonet] bottom of water bath

From:"DiCarlo, Margaret"

Hello Histonetters,


Working in a Bone Lab, I cut large sections which often require using 5
X 7 inch slides.  I finally found a new water bath which is deep and
wide enough for my lab needs.  Unfortunately, the inside of the water
bath is stainless steel which means silver in color.  Since it can not
be painted, does anyone have any suggestions as to what I can do or use
to make the bottom of the water bath black so I can see the tissue
easier?  I would appreciate your help.


Thank you. 

Peggy DiCarlo HT (ASCP)

Orthopedic Bone Lab

Buffalo General Hospital

100 High St.

Buffalo, NY  14203



2007 Best Places to Work Finalist 
Visit our careers page at www.kaleidahealth.org/careers

CONFIDENTIALITY NOTICE: This email transmission and any documents, files, or previous e-mail messages attached to it are confidential and intended solely for the use of the individual or entity to whom they are addressed. If you are not the intended recipient, or a person responsible for delivering it to the intended recipient, you are hereby notified that any further review, disclosure, copying, dissemination, distribution, or use of any of the information contained in or attached to this e-mail transmission is strictly prohibited. If you have received this message in error, please notify the sender immediately by e-mail, discard any paper copies, and delete all electronic files of the message. If you are unable to contact the sender or you are not sure as to whether you are the intended recipient, please e-mail ISTSEC@KaleidaHealth.org or call (716) 859-7777. 
Histonet mailing list

<< Previous Message | Next Message >>