Re-enbedding SPURR

From:Fabien Fuente

Hello everyone,
We are using Spurr for a while on rather big samples (about 1cm3). After
several successful embedded samples, we had recently experienced some
troubles with our last samples.

The resin didnot polymerized well in the center of the sample. We end up
with gummy and soft resin in the center of the sample.

As these samples are valuable, did anyone know a technique to remove this
unpolymerized resin and re-embed the entire sample without losing the

Thank you.

Fabien Fuente


Do You Yahoo!? -- Une adresse gratuite et en fran#231#ais !

Yahoo! Mail :

<< Previous Message | Next Message >>