|From:||Gayle Callis <firstname.lastname@example.org>|
If it has any GMA in it, you may be stuck, it cannot be removed, in fact, I
have never been able to remove PMMA from the outside polymerized bone
blocks, but the inside of bone will remain as is. Corrected bubbling this
way. Grind away as much plastic as possible, then immerse blocks into
methyl methacrylate monomer (pure) to dissolve away the PMMA from around
bone specimen, then reembed very carefully.
At 01:31 PM 10/20/00 +0200, you wrote:
>Have anyone experience removing Teknovit 7200 VLC (Kultser) from
bonespecimens and then re-embedding in PMMA.
>I have tried with acetone with no succes, normally i use acetone for
PMMA-bloks with good results.
Veterinary Molecular Biology
Montana State University
Bozeman MT 59717-3610
<< Previous Message | Next Message >>