We have made some in the past. We took a thumb screw and screwed it into
a couple of square nuts and then buffed off the excess to a smooth
surface on the bottom. Works swell and hardly any cost. Your engineers
or maintenance guys could make you some.
Hope this helps.
Terry J. Mattoon HT(ASCP)
VA Med Ctr. #113
White River Jct.,VT 05001
(802) 296-5193 (direct # to lab secretary)
802-296-6328 - FAX
On Mon, 09 Oct 2000 19:42:34 +0100 N Kenneison
> Hi there Histonetters
> If anybody can help me from Sakura or any othere supplier I am
> for a supplier of the small aluminium presses used when embedding
> Sort of T shaped when viewed side on and come in at least two sizes
> about 10 x 10 mm and 5 x 5mm.
> Any supplier would be of interest but especially in the UK - ours
> gone missing during a refurbishement and we wouild like to get some
> Tried the Sakura web site and catalogue but no luck - they are
> listed as
> beign in the original packing of the embedding centre and inthe
> handbookk but no catalogue number.
> Any help appreciated
> N Kenneison
<< Previous Message | Next Message >>