Although I don't know if you're using a Heraeus-Kulzer Technovit
product, I'm forwarding your question to their tech support people in
Germany (we're the US distributor for Technovit). They've been very
helpful in the past.
Very best regards,
Herrick, James L. wrote:
> Hello everyone,
> Does anyone have any experience with plastic embedding using Glycol
> Methacrylate (GMA), Methyl Methacrylate (MMA) or other products that
> could be used to embed vertebral specimens large enough that require
> approximately 100 mLs of solution to embed completely. The problem I am
> having using GMA is that the reaction becomes extremely hot and
> polymerizes into a block full of holes and bubbles. I would really
> appreciate any advice, protocols, etc., that you may have. Thanks.
> Histonet mailing list
Microwave Product Manager
Energy Beam Sciences, Inc.
29-B Kripes Rd.
East Granby, CT 06026
Tel: 800.992.9037 x 341
I skate to where the puck is going to be, not to where it's been.
- Wayne Gretsky
You must be the change you want to see in the world.
- Mahatma Gandhi
NOTE: This message, together with any attachments, is intended only for the use of the individual or entity to which it is addressed and may contain information that is legally privileged, confidential and exempt from disclosure. If you are not the intended recipient, however, there's not a lot I can do about it, and it was probably my mistake anyway. So please do the right thing and make this e-mail go away. Thank you.
Histonet mailing list