Of course, Joyce's remark is right on target.

when I first saw your post Roxanne, I wasn't quite sure if I understood entirely what you were asking.
for example, do you use the same blades in your new job as you used in the previous lab? if the answer is yes, then it is very unlikely that the angles used could be so different and both yield acceptable results.

the angle set on the microtome is directly related to the facet angle on the blade and of course this can vary between manufacturers.

in essence, you must find the correct angle to a degree through trial and error until your sections  have minimal compression. if the sections are rolling off the blade smoothly and with little compression, you are at the correct angle for that brand and model blade.

I am also not convinced that the angle setting between microtomes, especially between different brands of microtomes, are all that precise. what I mean is that if you used an angle of 10 on a Leica for example, you might need an angle of 8 or 12 on a microm. I don't know what the actual angle settings should be but you understand my point. even with a number of microtomes from the same manufacturer I've seen it occasionally necessary where the optimal setting on one might a  degree or two away from another. I believe these settings are intended as general guides. the ultimate proof is in the ease of sectioning and the quality of the sections you are getting from a particular machine.

back to Joyce's remark. as long as you are able to attain the quality required by your new employer, it matters little what angle setting you are using.


Vinnie Della Speranza
Manager for Anatomic Pathology Services
Medical University of South Carolina
165 Ashley Avenue  Suite 309
Charleston, SC 29425
Ph: 843-792-6353
fax: 843-792-8974

>>> "Weems, Joyce"  05/03/05 03:48PM >>>
I think you should be allowed to cut at whatever angle you produce the best sections! 
My 2 cents....Joyce:>)

-----Original Message-----
From: histonet-bounces@lists.utsouthwestern.edu 
[mailto:histonet-bounces@lists.utsouthwestern.edu]On Behalf Of Roxanne
Soto
Sent: Tuesday, May 03, 2005 11:45 AM
To: histonet@lists.utsouthwestern.edu 
Subject: [Histonet] cutting angle


What angles does everyone out there cut at and what kind of blades do you 
use?  I have always cut at 10 with high or low profile blades, but I have 
recently changed jobs and they cut at an angle of 21.  They were told that 
with high profile blades they should use an angle of 21.  I am having a hard 
time cutting at this angle.......
any thoughts?
Roxanne



_______________________________________________
Histonet mailing list
Histonet@lists.utsouthwestern.edu 
http://lists.utsouthwestern.edu/mailman/listinfo/histonet 


Confidentiality Notice ** The information contained in this message may be privileged and is confidential information intended for the use of the addressee listed above. If you are neither the intended recipient nor the employee or agent responsible for delivering this message to the intended recipient, you are hereby notified that any disclosure, copying, distribution or the taking of any action in reliance on the contents of this information is strictly prohibited. If you have received this communication in error, please notify us immediately by replying to the message and deleting it from your computer.
Thank you. Saint Josephs Health System, Inc.



_______________________________________________
Histonet mailing list
Histonet@lists.utsouthwestern.edu
http://lists.utsouthwestern.edu/mailman/listinfo/histonet