trimming GMA blocks
From: | Cathy Mayton <Cathy@wasatchhisto.com> |
I trim my GMA blocks with a band saw which was purchased at the hardware
store. The blades do not create the fine dust as you described. Fingers
are kept in tact by using a block of MMA (wood works as well) to push the
GMA through. I embed in peel-a-way molds and clamp right onto the block,
so I trim my blocks on the band saw into what looks like a "T". This saves
time and my tungsten carbide knives.
Koch is the name of the butcher supply house I believe Gayle was talking
about. I buy my nitrile gloves from them because they are less expensive
than the lab warehouses are.
Hope this helps.
Cathy
***************************************
GLP Compliant Laboratory
Cathy A. Mayton
Project Director
Wasatch Histo Consultants, Inc.
80 Youngberg Road
Winnemucca, NV 89445-5709
Voice: (775) 625-4425
Fax: (775) 625-1548
www.wasatchhisto.com
***************************************
<< Previous Message | Next Message >>