[Histonet] LINES IN PARAFFIN SECTIONS
I have a serious problem with lines/splits forming in my 5 micron
sections as they come off the microtome.
I just started using Paraplast Xtra Tissue Embedding Medium.
My infiltrating wax is regular Paraplast.
My disposable blades are Surgipath high profile Teflon coated blades.
The microtome is a Microm HM 355S.
I cut human brain tissue exclusively.
I had been using Surgipath embedding media.
I decided to try the X-tra because I had been having problems with the
sections being thick and thin on just one side of the section.
Also the wax seeming to be thicker (more opaque) on one side of the block.
The blocks of tissue also were not laying flat in the mold, hence a lot
of trimming after.
There was some problem with lines even with the Surgipath but it was
intermittent., and not nearly as bad as the X-tra.
I notice that trimming requires more physical effort with the Paraplast
And I have had much more of a problem with lines than with the Surgipath
Does it have a higher % of plastic in it.
I cleaned out the reservoir on the embedding center and played with the
knife angle but to no avail.
I am not sure if the lines have to do with the wax or the blades or both.
Thank you for any advice you can give me.
Harvard Brain Tissue Resource Center
Any information, including protected health information (PHI), transmitted
in this email is intended only for the person or entity to which it is
addressed and may contain information that is privileged, confidential and or
exempt from disclosure under applicable Federal or State law. Any review,
retransmission, dissemination or other use of or taking of any action in
reliance upon, protected health information (PHI) by persons or entities other
than the intended recipient is prohibited. If you received this email in error,
please contact the sender and delete the material from any computer.
Histonet mailing list
<< Previous Message | Next Message >>