Re: [Histonet] Slide Press?
We use a PROXXON model maker's vice. this allows one to clamp slides
and transport them to the incubator. If you want, I can look up the
model number for you, as I do not have it to hand right now
best regards
On 1/10/06, Amy Porter wrote:
> I have had a question posed to me by our e.m. technician about a "slide press" to weigh down section of bone that have been embedded in resin. Does anyone out there know what this is or know of a vendor where one may be purchased. Thanks in advance for all of the responses.
>
> Amy S. Porter, HT(ASCP) QIHC - Supervisor
> Michigan State University
> Laboratory for Investigative HistoPathology
> Department of Physiology / Division of Human Pathology
> 2100 Biomedical Physical Sciences Bldg. Room #2133
> East Lansing, MI 48824-3320
> Phone: (517) 355-6475 ext 1480 / Fax: (517) 432-1368
> Email: portera@msu.edu
> www.humanpathology.msu.edu
>
> _______________________________________________
> Histonet mailing list
> Histonet@lists.utsouthwestern.edu
> http://lists.utsouthwestern.edu/mailman/listinfo/histonet
>
--
Louise Renton
Bone Research Unit
University of the Witwatersrand
Johannesburg
South Africa
"....onwards through the fog!"
_______________________________________________
Histonet mailing list
Histonet@lists.utsouthwestern.edu
http://lists.utsouthwestern.edu/mailman/listinfo/histonet
<< Previous Message | Next Message >>