If you have an embedding center demo that cannot control the cold plate temperature, get another manufacturer. It would not be wise to buy something that even from the start cannot do what you need and is causing problems.
  Contact another rep with this problem and get another demo from another maker. This is a problem you can eliminate early.
  René J.

"Margiotta, Michele"  wrote:
  Hi All,

I also have a similar ? about cracks in paraffin blocks. We are demoing a new embedding center and have been getting cracks in our blocks. Unfortunately, the cold plate temp can't be adjusted and is supposedly set at -5C. Any other ideas how to prevent this from happening? Thanks!

Michele Margiotta
BMHMC
Histology Supervisor
631-654-7192




This e-mail and any files transmitted with it are confidential and are intended 
solely for the use of the individual or entity to which they are addressed. 
This communication may contain material protected by the attorney-client 
privilege. If you are not the intended recipient or the person responsible for
delivering the e-mail to the intended recipient, be advised that you have received 
this e-mail in error and that any use, dissemination, forwarding, printing, 
or copying of this e-mail is strictly prohibited. If you have received this e-mail in 
error, please immediately notify the sender via return e-mail or call
Brookhaven Memorial Hospital Medical Center at (631) 654-7282.



_______________________________________________
Histonet mailing list
Histonet@lists.utsouthwestern.edu
http://lists.utsouthwestern.edu/mailman/listinfo/histonet


       
---------------------------------
Never miss a thing.   Make Yahoo your homepage.
_______________________________________________
Histonet mailing list
Histonet@lists.utsouthwestern.edu
http://lists.utsouthwestern.edu/mailman/listinfo/histonet