Re: [Histonet] mouse embryo section tears

From:Sharron Ladd

I just did a bunch of mouse embryos (and placentas). I asked the 
researcher to fix them in Bouins fixative ( for less than 24 hours) 
since I had read that this was the best (non-mercury) fixative for 
embryos. I also asked that the researcher start dehydration at 30% 
alcohol and give them to me in 70% alcohol. The embryos cut like butter. 
Bouins fix will lyse red blood cells and those red cells/blood might be 
what is causing you problems in the liver area? I wonder if what you are 
calling tears is actually "chatter"? Are you soaking the block in ice 
water before sectioning?  This might alleviate your problem.  I also cut 
mine at 7 microns but I didn't have to soak the block and I did not have 
any problems with chatter. Obviously, going back and changing the 
fixative is not an option, but maybe next time you could try Bouins?
Sharron
University of South Florida


Rashmi Chandra wrote:

> I am sectioning paraffin embedded mouse embryos (fixed in 4% 
> paraformaldehyde) at 7 microns. The sections cut and ribbon fine but 
> after i dry them on the slide, tears appear in the liver. These tears 
> are not present when I first check the sections after lifting them 
> from the water bath (temperature 37 C) onto the slide.  I think the 
> tears may result from differential drying of the various tissues, and 
> I am looking for a way to prevent them.
>
> Thanks a lot for your advice!
>
> Rashmi
> __________________________
> Rashmi Chandra, Ph.D.
> Dept. of Neurobiology
> Duke University Medical Center
> Durham, NC 27710
>
> Tel: (919) 681-5449
>
> _______________________________________________
> Histonet mailing list
> Histonet@lists.utsouthwestern.edu
> http://lists.utsouthwestern.edu/mailman/listinfo/histonet
>


_______________________________________________
Histonet mailing list
Histonet@lists.utsouthwestern.edu
http://lists.utsouthwestern.edu/mailman/listinfo/histonet


<< Previous Message | Next Message >>