We've been routinely sending out blocks for sectioning (we're a bit short
handed at the moment) with out any problems until recently.
The slides I got back looked fine. After HIER, though, the tissues on them
just kept peeling off as I was staining them....
So, I had them sent out again and the sections put on super charged slides.
Well, while the tissues didn't peel off as much, I still lost a fair
Is there any way to prevent this?
Any way to reduce peeling after HIER?
Or, am I *@#!! out of luck?
My samples represent too much work to watch them being lost.
Thanks in advance!
Histonet mailing list
<< Previous Message | Next Message >>