Mouse Embryos

From:Histo-Scientific Research Laboratories <histosci@shentel.net>

Dear Histonetters,

We are having burning problems with our mouse embryos.  They are neonates
that are about two cm long and about 1 cm wide- so they are fairly large
embryos.  They are fixed in 10%NBF for 24 hours then stored in 70% ETOH.
They have been cut down the belly for proper fixation.  We are using a
Tissue Tek, VIP  and our processing schedule is: 2  70% for 40 mins each, 1
80% for 40 min. 2 95% for 40 mins each, 3 100% for 40 mins each, 2 xylenes
40 mins each (no heat, PVC cycle on for all alcohols and xylenes), 4
paraffin changes (paraplast, 56 degree melting point) for 30 mins each on 60
degrees.  We have talked with both Bel-Air and Sakura to see if it was the
processor itself, and we have ruled that out.  We change all of our reagents
every 5 cycles- once per week.  We also do a daily clean which consists of
discarding the first 70%, moving #2 up and replacing, discarding the first
100%, moving #2, and #3 up and replacing and the first paraffin and
replacing with new.  No matter how fresh the reagents, we are still having
severe shrinkage and burning of these embryos.  Our other tissues are fine.
Could anyone tell me what we may be doing wrong?  All thoughts are greatly
appreciated.

Sincerely,

Tom Galati
HSRL
137 South Main Street
Woodstock, VA  22664
(540)459-8211
fax: (540)459-8217
www.hsrl.org
tomgalati@hsrl.org




<< Previous Message | Next Message >>